In the manufacture of SANDAO rtv silicone , the product adopts high technologies. These technologies include reverse osmosis, membrane filtration, or ultrafiltration. 2.
It has undergone significant enhancements in capabilities. 3.
If washed with hot water or dried with a dryer, the product is not easy to shrink. 4.
Being distinctive, it increases the curiosity to explore and discover. Its design will resonate with a unique category of consumers.
Silicone adhesive sealant SD906
Silicone adhesive sealant SD906 is a one-component RTV silicone rubber with high strength, good thixotropic properties, neutral non-corrosion, high temperature resistance, high pressure resistance, solvent resistance, low shrinkage and no collapse. Suitable for large gap (0~6mm) adhesive seal, waterproof, oil proof, impact resistant.
The RTV silicone adhesive sealant SD906 is suitable for bonding and sealing of refrigerators, microwave ovens, circuit boards, electronic components and machinery. This silicone rubber SD906 can be applied to metals, glass, ceramics, plastics, etc.
Microwave oven adhesive seal
Refrigerator bonding seal
Semiconductor material bonding
|Color||Colorless transparent ||white||black|
|Tensile strength (MPa)||2.0||2.0||2.0|
One-component RTV silicone rubber
SD906 (silicone adhesive sealant) is a one-component RTV silicone rubber
Neutral non-corrosion, odorless, non-pollution, good viscosity and fluidity.
Milky white paste
After curing, it has high temperature resistance, high pressure, solvent resistance, low shrinkage and no collapse.
100g/tube 310ml/cartridge 2.6L/bottle
The surface of the substrate must be cleaned, and well-distributed can improve the bonding effect(thickness not exceeding 6 mm).
The silicone adhesive sealant surface curing time of about 20 minutes and fully cured after 24 hours.
Packaging and preservation
Packing specification: 100g/pcs ,300ml/pcs, 2600ml/pcs.
Storage: stored in a cool and dry place for one year.
1.Wet air is needed for curing and solidify. It may take more time for curing if bonding surface is large.
2.Please tighten the capping tube after use to prevent colloid solidification in the tube. If there is solidification at the end of the pipe, remove the solidified material and use it as usual.
3.Keep thermal paste out of reach of children.
4.Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer. This product has not been tested for, and is therefore not recommended for, uses for which prolonged contact with mucous membranes, abraded skin, or blood is intended; or for uses which implantation within the human body is intended.
With years of concentration on the design and production of rtv silicone , Huizhou SANDAO New Material Co., Ltd has been a competent manufacturer in the industry. 2.
We have a team that is responsible for product management. They manage a product throughout its life cycle focusing on safety and environmental issues at each phase. 3.
We fight for a sustainable future. We have been working to minimize the total resources used, and are continuing to increase resource collection through the introduction of new recycling technologies and systems to expand the usage of recycled resources. We act proactively to fight against negative environmental issues. We have set up plans and hope to reduce water pollution, gas emissions, and waste discharge. We aspire, as part of our vision, to be a trusted leader in changing the industry. To realize this vision, we need to earn and maintain the trust of employees, shareholders, clients, and the society we serve. We make efforts to advance sustainable practices. During our production, we make efforts to reduce production pollution&waste and improve energy efficiency.