Paintless dent repair (PDR) technicians all over

by:SANDAO     2020-06-19
Here are the steps involved: Step 1: Inventory your kit: Glue and glue gun.(Plug in glue gun now.) Dent puller. (aka: PDR slide hammer) Knock down. Glue tabs. Solvent. Soft rags. Step 2: Identify the damage. Step 3: Wipe damaged area with soft rag and solvent. Step 4: Find tab that just fits inside the damaged area. Step 5: Apply glue to tab surface and apply to dent. Step 6: Allow for short cool down time. (About 25-45 seconds) Step 7: Attach dent puller and pull the dent. Step 8: Use solvent to clean off remaining glue from both panel and tab. Step 9: Using hammer and knock down, tap down anything that looks high. Step 10: Repeat process until desired results are met. You can find the high and low areas of the damage by using florescent light bulbs shining across the damage. The reflection of the bulb will bend when it crosses the dented area. When you tap down anything that is high, be patient. Tap lightly but consistently on the high areas but not too hard at first. Hopefully, this will help you use any dent pulling system or kit, like the 'Pops a dent' or 'Twist a dent' or any other that may be out there. Duane Langenfeld is a PDR tech of 15 years. He has repaired over 20k vehicles since his start and loves training new techs. Click here for 'THE DENT PULLER'
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...