SANDAO what is rtv silicone is of revolutionary design. It is an outcome of the expertise on the part of the building designer, the manufacturer, the fabricator, and the installer. 2.
This product provided by SANDAO is at the best possible rate with the best quality. 3.
With the world’s advanced automatic production line and computer detection equipment, the quality of this product is guaranteed. 4.
Our offered product is widely applauded by our clients due to its incomparable features.
Thermal conductive silica gel SD916
Thermal conductive silica gel SD916 has both bonding and good thermal (heat dissipation) properties. The thermal conductive silica gel is a reinforced neutral silicone elastic rubber. After curing, the rubber has good resistance to high and low temperature changes. It will not fall off after long-term use, and will not cause contact gaps to reduce heat dissipation.
The most important application is to replace the thermal grease (paste) for the filling and bonding between the CPU and the heat sink, the thyristor intelligent control module and the heat sink, the high-power electrical module and the heat sink.
Microwave oven adhesive seal
Radiator filling and bonding
Refrigerator bonding seal
Semiconductor material bonding
Thyristor filling and bonding
|Tensile strength (MPa)||≥2.5||≥2.5||≥2.5|
|Hardness (shore A)||50～65||50～65||50～65|
|Thermal conductivity（w/(m.k)） ||1.2||0.8||2.0|
Thermal conductivity paste
SD916 thermal silica gel is a one-component Room temperature curing adhesive It has both bonding and good thermal (heat dissipation) properties.
Neutral non-corrosive, odorless, non-pollution,Is a reinforced neutral silicone elastic rubber.
After curing, it has excellent resistance to high and low temperature, will not fall off after long-term use, and will not produce bonding gap to reduce heat dissipation effect.
Metal hose packaging
Packaging specifications: 100g /tube, 310ml/ plastic cartridge,2.6L/ bottle
Cleaning the surface of the adhered or coated object to remove rust, dust and oil.
Unscrew the rubber cap and squeeze the glue onto the cleaned surface to make it evenly distributed.
Place the glued or sealed parts in the air to allow them to cure naturally. The curing process is a curing process from the surface to the inside. The glue will cure to a depth of 2-4 mm within 24 hours (room temperature and 55% relative humidity). If the position is deep, especially in areas where air is not easily accessible, The time to complete cure will be extended, and if the temperature is lower, the cure time will also be extended.
1. Keep thermal paste out of reach of children.
2. Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer. This product has not been tested for, and is therefore not recommended for, uses for which prolonged contact with mucous membranes, abraded skin, or blood is intended; or for uses which implantation within the human body is intended.
Huizhou SANDAO New Material Co., Ltd is professional enough to provide the most attentive service and the best One-component RTV silicone rubber TDS. 2.
Quality is above everything in Huizhou SANDAO New Material Co., Ltd. 3.
We manufacture products through economically-sound processes that minimize negative environmental impacts while conserving energy and natural resources. We are committed to consuming less, producing less waste, and reusing or recovering value from waste. During the production, the wastewater will be treated by advanced waste management facilities to reduce pollution.