Be certain to end with a really nice grit of sandpaper , otherwise, you will see sanding marks whenever you pour the next layer of resin. If you need to try, I would certainly seal them before utilizing them in resin. @MK, if they're just a little sticky , then yes, a transparent coat of an acrylic based spray paint ought to be fantastic. @Heidi, in trying on the link you included in your remark, it doesn’t look those art works were created using resin. @Gail, I would try making use of another layer of resin to the tray.

@Lisette, I’m unsure the completed product will be secure. I’m thinking you'd have better luck decoupaging the magazines over an already created type.

I am interested in make a seashore themed desk; sand, seashells after which overlaying it with resin. Does anybody know one of the simplest ways to do this or how resin and sand work together. I’m using liquitex gloss medium varnish over the acrylic and on the wooden the place the bubbles/fuel forms. If I have been going to try this project, I would sand down/off the highest layer of resin such that each one the defects are sanded out.

Unfortunately, you'll have to recoat the entire surface. It ought to, but depending on the amount of curve, you may want to observe the piece for a period of time to remove drips. A minimum of two coats, front and back, then glue into the bezel. Is there a certain sort of epoxy I should use for this kind of job?

I would counsel filling the bubble area with more resin. Unfortunately, I don’t have any nice ideas to suspend them. I’m thinking it would be great to have them grasp upside down such that the resin may drip off the factors.

I would counsel getting in contact with the producer to get their recommendations on the maximum quantity to mix without delay. I’m joining countertops together and we used 3m aluminum tape. What would you recommend to carry the resin in the joints so it doesn’t pour out from the bottom of the joint when joining the 2 countertops.

No, I don’t have a means of suspending them to glaze them. I am going to check on a number of additional slices that didn’t come out even simply to see how the resin will act as a glaze. Deer shed them and I find them and use them in my jewelry. Im a licensed cometologist and im in a giant present i would like to knw more in regards to the proportions to make use of and what to make use of to paint it on. Polypropylene usually doesn’t persist with resin, but I don’t assume you'll get the clean lines you need.