Using high-quality raw materials, SANDAO rtv silicone has a fine appearance. The product has good aging resistance2.
One-component RTV silicone rubber TDS boast of its good service and high quality. It should be fully cured before realizing its use value3.
Our plant has perfect quality assurance system and production guarantee system for this product. It has excellent electrical insulation performance4.
The product is guaranteed to be of high quality and excellent performance as all factors that affect its quality and performance in the production would be detected immediately and then corrected by our well-trained QC staff. Without any halogen, it is healthy and environmentally friendly5.
In addition to quality that meets industry standards, this product has a longer life than other products. It is corona-resistant and has good resistance to electric leakage
Thermal conductive silica gel SD916
Thermal conductive silica gel SD916 has both bonding and good thermal (heat dissipation) properties. The thermal conductive silica gel is a reinforced neutral silicone elastic rubber. After curing, the rubber has good resistance to high and low temperature changes. It will not fall off after long-term use, and will not cause contact gaps to reduce heat dissipation.
The most important application is to replace the thermal grease (paste) for the filling and bonding between the CPU and the heat sink, the thyristor intelligent control module and the heat sink, the high-power electrical module and the heat sink.
Microwave oven adhesive seal
Radiator filling and bonding
Refrigerator bonding seal
Semiconductor material bonding
Thyristor filling and bonding
|Tensile strength (MPa)||≥2.5||≥2.5||≥2.5|
|Hardness (shore A)||50～65||50～65||50～65|
|Thermal conductivity（w/(m.k)） ||1.2||0.8||2.0|
Thermal conductivity paste
SD916 thermal silica gel is a one-component Room temperature curing adhesive It has both bonding and good thermal (heat dissipation) properties.
Neutral non-corrosive, odorless, non-pollution,Is a reinforced neutral silicone elastic rubber.
After curing, it has excellent resistance to high and low temperature, will not fall off after long-term use, and will not produce bonding gap to reduce heat dissipation effect.
Metal hose packaging
Packaging specifications: 100g /tube, 310ml/ plastic cartridge,2.6L/ bottle
Cleaning the surface of the adhered or coated object to remove rust, dust and oil.
Unscrew the rubber cap and squeeze the glue onto the cleaned surface to make it evenly distributed.
Place the glued or sealed parts in the air to allow them to cure naturally. The curing process is a curing process from the surface to the inside. The glue will cure to a depth of 2-4 mm within 24 hours (room temperature and 55% relative humidity). If the position is deep, especially in areas where air is not easily accessible, The time to complete cure will be extended, and if the temperature is lower, the cure time will also be extended.
1. Keep thermal paste out of reach of children.
2. Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer. This product has not been tested for, and is therefore not recommended for, uses for which prolonged contact with mucous membranes, abraded skin, or blood is intended; or for uses which implantation within the human body is intended.
Huizhou SANDAO New Material Co., Ltd continuously carries out technological research and industrialization exploration of rtv silicone .2.
We shared with a vision of delivering consistently great results for our clients, as well as ensuring the agency is a fun, inclusive, challenging place to work and develop a rewarding career. Contact us!